- 125% Stronger Traction Power
This is a product with strong traction and board support range using the Disk Dr's VAP technology; it is designedas an intensive care model in the Disk Dr. series, which is intended for patients with chronic or severe low back pain.
- The effects were approved through clinical tests.
Clinical tests carried out at the University of Inje Medical School in Korea
approved Disk Dr.'s traction effects. The clinical report showed that 90.5%
of the subjects experienced pain relief.
- Overcoming back pain without surgical operation
The VAP technology of Changeui Medical produces traction force on the
lumbar section from L1 to L5, easing the pressure imposed on each
vertebra and producing space between the intervertebral discs up to 3 mm
to soothe pain.
The Disk Dr. WG50 DOUBLE is the perfect solution for patients who cannot tolerate the discomfort of a rigid body jacket yet require similar support. It is especially valuable for pre and post surgery, providing with equal stability as a stiff body jacket. As the patient progresses and requires less support, the detachable rigid panels can be removed to create a semi-rigid support with one or no support panels. It easily converts to a soft LSO and provides greater flexibility.
Product Construction and How to Use
The Double Disk Dr. is designed to have double effect on the patient for the treatment of the disc.It is recommended for the patients who are suffering from severe disc.
1- Before use,make sure that the device is completely deflated by turning air valve counterclockwise to release air.After device is completely deflated,return valve to locked position by turning valve clockwise until the valve is fully tightened.
2- Place device around your abdomen, underneath your ribcage and above your hip and pelvic bines,with the Disk Dr.logo in the upright position and lined up with the center or the abdomen.
3- Put on the lower part of belt first,then the upper part of belt .The device should
be fastened around the waist fairly,however not too tight.
4- To connect the hand air pump valve to the device air valve, open the spring loaded clamp by pushing the clamp arms together, insert the tongs of the hand air pump valve into the designated grove of the device air valve and securely place hand pump air valve over the device air valve.
5- Proceed to inflate device by moving the handle up and down repeatedly until the belt is inflated completely or until the needle in the air pressure gauge moves into the green-yellow areas(10/14 psi). Caution:Do not allow needle to exceed into the red area of the air pressure
gauge.By doing so can damage device.
6- Remove hand air pump valve from the device,the device is ready to wear.Prior to removing the device from your body,you MUST first release the air from the device by turning the air valve counterclockwise to release air.
on any order over then 50$
contact us on +961 1 451245
Monday to Friday
8:00 am - 6:00 pm
in 48 hours